Tool

ISO 9001 Audit-Days Calculator

An indicative ISO 9001 audit time from IAF MD 5 — the same table we use to build your quotation. The final figure follows review of your application.

Your organisation

All shifts, including contractors under your control

Indicative audit time

Effective personnel: 25

Initial audit (Stage 1 + Stage 2)
3 days
Each surveillance audit (years 1 and 2)
1 days
Recertification audit (year 3)
2 days
  • Adjustments under IAF MD 5 can increase the initial figure, or reduce it to no less than 2.5 days.
  • Indicative only — final quote after application review.
Request a fixed quotation

Reference

IAF MD 5 Table QMS 1 — initial audit time

Stage 1 and Stage 2 together, before adjustment.

Effective personnelInitial audit days
1–51.5
6–102
11–152.5
16–253
26–454
46–655
66–856
86–1257
126–1758
176–2759
276–42510
426–62511
626–87512
876–117513
1176–155014
1551–202515
2026–267516
2676–345017
3451–435018
4351–545019
5451–680020
6801–850021
8501–1070022

Above 10,700 people the progression continues and the figure is set at application review. See also audit time and effective personnel.

Common questions

Audit days and cost — questions

From IAF MD 5, a mandatory document that certification bodies apply. The starting point is a table that sets initial audit time (Stage 1 and Stage 2 together) from the effective number of personnel. The figure is then adjusted for factors such as process complexity, design responsibility, outsourcing, the number of sites and shift patterns.

Yes, for defined reasons — for example, low-risk processes or a very limited scope — but IAF MD 5 does not allow a reduction of more than 30% from the table figure. A quotation far below that is cutting the audit.

The fee is driven mainly by audit days across the three-year cycle: the initial audit, two surveillance audits and recertification. The calculator shows the days; the quotation applies the day rate, plus travel at cost where relevant. See ISO 9001 certification cost for how the fee is built.

Everyone whose work is within the scope of certification, on all shifts — permanent, temporary and part-time staff, and contractors working under your control. Part-time staff are counted in proportion to the hours they work.

No. It is indicative only. The final audit time is set after review of your application, when the scope, sites, shifts and complexity are known, and it is shown with the calculation in your quotation.

Question not answered here? Ask a certification specialist — we answer technical questions without requiring an enquiry first.

Next step

Get the exact figure for your organisation

Send us your scope, headcount, sites and shifts. The quotation shows the audit-day calculation and the full three-year cost.